I am impressed at how wellI am impressed at how well the scanners work for my Mobile DJ service. Special thanks to Jay for gettingback to me right away with all the emails I sent! ![]() Scotty |
The Terminal 1010x takes the DSP Experience to the next level with an intuitive front-panel that enables users to control 10 analog balanced inputs for Mic/Line/+48V and 10 balanced outputs. There are also 6 flexible RAD Plus PoE ports to connect breakout boxes and wall plate remote controls and 4 Universal GPIO logic ports for external devices such as alarm systems, sensors, lights, projectors, etc. There is also a slot for an optional DANTE 32x32 card for network connectivity.
Features:
Package Contents:
Specifications:
Analog I/O:
Type: 10 in x 10 out
ADC: High definition audio 24-bit, 48kHz, DR 116dB A-weighted
DAC: High definition audio 24-bit, 48kHz, DR 116dB A-weighted
Frequency Response: 20Hz–20kHz, ±0.1dB
Inputs:
Connection: (5) Euroblock connectors, 6 pins each, 3.81mm pitch, green. Ships with strain relief plugs.
Condenser Mic Mode:
Type: Active balanced, microphone input mode with 48V phantom power
Phantom Power: +48V
Maximum Input: 1Vrms
Input Impedance: 2.5kΩ: Each leg
Dynamic Mic Mode:
Type: Active balanced, microphone input mode without phantom power
Maximum Input: 250mVrms
Input Impedance: 2.5kΩ: Each leg
Line Mode:
Type: Active balanced, line-level
Maximum Input: 8Vrms
Input Impedance: 5kΩ: Each leg
Line+ Mode:
Type: Active, left [+] & right [-] signals summed to mono
Maximum Input: 8Vrms
Input Impedance: 5kΩ: Each leg
Outputs:
Connection: (5) Euroblock connectors, 6 pins each, 3.81mm pitch, orange. Ships with strain relief plugs.
Type: Active balanced, line output mode with active output transient muting
Maximum Output: 8Vrms
Impedance: 300Ω: Each leg
Frequency Response: 20Hz–20kHz, ±0.1dB
DSP:
Processing Power: >10,000 MIPS
Word Length: 32-/64-bit Floating Point
Delay Memory: Min. 160sec total
Computer Interface:
Type: Ethernet 1000 base-T: Zeroconf service discovery protocol for easy setup
Connection: RJ-45: Shielded Cat 5e cable or better
Length: 300ft./100m: Standard Ethernet cable length limit
RAD+ Ports:
Connection: (6) RJ-45: Shielded Cat 5e cable or better
Audio Channels: 2 in, 2 out: Each port, control channel 24-bit, 48kHz
Voltage: 27 VDC: Each port
Power: 12W (peak)/6W (average): Each port
Length: DR devices: 984ft./300m: RAD devices: 325ft./100m
Universal Logic I/O:
Connection: (1) mini-Euroblock connector, 6 pins, 3.81mm pitch, black
Logic In:
Internal Pull-Up: 5mA: Protected to +24V, reverse-polarity-protected
Vin High: > 2.2V: Normal state
Vin Low: < 1.0V
Logic Out:
Open Collector Output: Source 5mA, Sink 200mA Protected to +24V, reverse-polarity-protected
Vout High: > 2.2V
Vout Low: < 0.2V
Ratiometric Input:
Input: 0–5V
V+: 40mA
Resolution: 8-bit at 2kHz sample rate
Expansion Port:
Types:
Rane Expansion Bus: 512 x 512, 48kHz digital audio plus control. Up to 32 Halogen Expansion Devices
Dante card (optional): 32 x 32 with sample-rate conversion, allowing 96kHz sample rate Dante flows
Connection: RJ-45: Shielded Cat 5e cable or better
Maximum Length: 300ft./100m
Power:
Connection: IEC
Voltage: 90–260VAC, 50/60Hz
Consumption: 70W
Output: 28V
Unit:
Wiring: Class 2: Rear-panel terminals
Operating Temperature: 32–104°F, 0–40°C
Fan: 10CFM, low noise (<20dBa), long life (60k hours at 45°C)
Dimensions: 19.0" x 8.25" x 1.73"
48.3cm x 20.9cm x 4.4cm: Width x depth x height
Weight: 7.0 lbs., 3.2 kg