General Description

Very simple. You and up to three other friends want to listen to the same mix under headphones. Just take the HC 4, plug in, turn on, adjust your individual volumes, and groove away.

The HC 4 provides master stereo Inputs which can be used to drive the four stereo headphone amplifiers. A Mono switch is provided on the front panel to drive both channels of all four amplifiers from a common mono source.

The HC 4 is capable of delivering up to 200 milliwatts into headphones with rated impedances between 32-600 ohms. The precise amount of power depends on the exact impedance of the headphone in use and the number of headphones connected to the unit. Under most conditions, the HC 4 produces sound pressure levels in excess of 120 dB. This level is more than adequate for most listeners. See "Understanding Headphone Power Requirements", with an output listing of available headphones.

See the Data Sheet below for complete specifications.

Rear Panel

Product Literature

• Data Sheet (100k)
• Manual (150k)
• Schematics (300k)

Further Information

• JPG: HC 4 high-res RGB 2400 pixels wide x 300 ppi
• "Understanding Headphone Power Requirements"
• Rane Audio Reference