|
Contractor
Series
Major Features
CH SERIES DRIVES MULTIPLE IMPEDANCES
CH Series provides for both low impedance or high impedance outputs per
channel.
Each channel offers 4/8 ohm, 70V and100V operation on CH1 and CH2, and 4/8
ohm and 70V on CH4.
Loads can be mismatched, allowing for independent operation per channel.
CH SERIES INCLUDES HPF PER CHANNEL
All CH Series include a 70 Hz High Pass Filter per channel, providing
necessary low frequency roll off to eliminate saturation of constant voltage
step down transformers typically used in 70V and 100V distributed systems.
SHALLOW CHASSIS DESIGN
The CH 1, CH 2, and CL 1, and CL 2 use shallow chassis, allowing for
installation in most wall-mount equipment racks.
SECURITY
Rear panel level controls for secure operation.
Precision detented level controls allow for accurate level settings in many
fixed installation applications.
CONTRACTOR CORRECT CONNECTORS
Barrier strip output connectors allow for quick easy connection, regardless
of the load.
Barrier strips accept up to 10 Awg. crimp-on terminal forks.
5-WAY FAULT INDICATOR
1) blinks during power-mute; 2) excessive heatsink temperature; 3)
transformer thermal protection; 4) short at amplifier output;
5) output stage non-operational.
FLEXIBLE INPUT OPTIONS
Active crossover with signal routing available with optional System Solution
Topology
modules (SST-SBSC, SST-SX and SST-MX).
CL SERIES AND 2 OHM OPERATION
When low impedance is the only requirement, the CL Series includes high
power 2 ohm operation.
THE BEST VALUE ON THE MARKET
Dollar per Watt comparisons in this class prove how the new CH/CL Series
are hard to beat.
Specifications
|
